Drive Shaft U Joint Tool
Using a 2x4 or some tool to support the shaft,. You’ll need a spirit level or digital protractor accurate to ¼ degree.
Too small of tips will bend or break making the job take all day.
Drive shaft u joint tool. Shown are some boot removal and installation tools. A step by step guide for how to disconnect drive shaft for towing? Drive axle clamp swage tool applications:
Chevy pickup, chevy corvette late 60s to 70s. Use this special wrench to remove and install the 5th gear locknut on the output shaft in 2 & 4 wheel drive vehicles equipped with the nv4500 manual transmission. The ideal tool for disassembling drivelines.
As far as inspecting the u joints, your have to get under the car and grab the appropriate shaft and turn it back and forth while watching the appropriate u joint for play. As far has tools were concerned i used a combination of the harbor freight u joint tool as well as my large bench vise. Also for push pin removal on honda, toyota and saturn cars.
To remove the shaft on my 2500, is the only other step to remove the two bolts on the support bearing and drop it with the shaft. The u niversal joints allow drive shafts to move up and down with the suspension while the shaft is moving so power can be transmitted when the drive shaft isn’t in a straight line between the transmission and drive wheels. A universal joint operating angle is the angle that occurs between the driving member and driveshaft, and between the driven member and driveshaft when they are not vertically aligned.
Place the bike on the centerstand. You just need to be careful not to let the needle bearings fall as you install them. Available through ural dealers only.
Get drive shaft in position (make sure it is lined up with your marks, you did make marks right?) Use on ford 1950 through present. 1992 thru 1994 do not use power tools.
This calculator does not address compound drive angles (horizontal offsets). Breakage due to use of power tools voids your warranty. Use a good pair of snap ring pliers with tips just small enough to work.
Serviceable (what we don’t have): Also make sure you remove the retaining clip before trying to remove the old u joint from the yoke. A cotter pin removal tool (above) works very well.
Take off the driveshaft flange; Fits practically all class 7 and 8 trucks, including: Use a scotch brite pad to remove any burrs.
Will not damage the driveshaft, yoke, bearing cups, or joints. All i had to do was unbolt the end at the differential and then slide the spline out to replace the u joints. I found that the warn alloy inner shafts and the hardened.
Tape the 1410 side of the u joint using electrical tape or similar to keep the end caps on the joint when installing. For universal joint snap rings used on hotchkiss drive shafts.
0 Response to "Drive Shaft U Joint Tool"
Post a Comment